Make sure that you set UCS (user coordinate system) to WORLD and that you do not modify the Vpoint. If you are designing a mask for a microsensor you should draw in units of microns - i.e., a line of width 5 represents 5 um wide. Common GDSII units are in microns for most semiconductor applications. You should work in the units that the final GDSII system will use if possible. AutoCAD's UNITS command affects only the display and does not set drawing units. Failure to do this may result in the GDSII data snapping to the nearest grid point and possibly corrupting your intent.ĪutoCAD is dimensionless. This will insure that each point entered in AutoCAD can be exactly mapped to GDSII. A typical grid value if you were drawing a semiconductor would be 0.5, 0.1, 0.25, 0.01 or even 0.001 for units of microns. To get a GDSII database that exactly corresponds to the AutoCAD drawing, you should set a grid in AutoCAD and then use that grid for snap purposes. GDSII is an integer database AutoCAD uses a double precision database that is not really grid based. Since your intention is to transfer information accurately to GDSII you should set up your AutoCAD drawing environment as closely as possible to the equivalent drawing environment for GDSII systems. Setting up the AutoCAD Drawing Environment
![download doa qunut raihan download doa qunut raihan](https://image.slidesharecdn.com/doaqunut-140403054202-phpapp02/85/doa-qunut-1-320.jpg)
![download doa qunut raihan download doa qunut raihan](https://i.pinimg.com/236x/4f/74/0b/4f740baba5b032c99990f4bc9a5c71ca--doa-quran.jpg)
This document summarizes good drawing practices. Since the GDSII file is usually processed one more time to create mask data, there may be additional limitations imposed on what you may draw by the mask making machine. Therefore, not every entity in AutoCAD has a corresponding element in GDSII. The two databases are not organized alike.
#Download doa qunut raihan software
Drawing Design Rules for DXF to GDSII Drawing Design Rules for DXF to GDSII Steve DiBartolomeoĪSM 3500 converts AutoCAD DXF files into GDSII so that AutoCAD users can send their drawing files to IC design software or to mask making machines.